SCOUT ARMOR: THERMAL DETONATOR STRAPPING

A lot of people have asked me about how to strap the Thermal Detonator on the belt.  There are many ways to do this.  The most common is using the belt clips that attach to the belt after it has been put on just like the TK armor.

However, we all know when there is limited help or handlers during a troop, we want to make it as easy as possible to suit up and suit down.  Here is how I strapped the TD on the TB belt.

It’ll look seamless like this and will be permanently attached to your belt like this:

TB_belt1

I drilled 4 holes onto the female side of the belt clip after attaching the main tie strap (black through the center).

TBbelt_2

NOTE: You’ll have to make careful measurements before drilling. Look at the male side of the belt clip and make sure the release tabs will clear the holes so that you can release and unclip the belt.

TBbelt_3

After drilling the holes, I ran 2 tie straps to secure the TD to the belt. Test fit the belt clip, adjust it to the correct place and secure it tightly in place and you’re done! Now you don’t have to worry about losing the TD and worry about clipping this piece behind you without any help.

TBbelt_4

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s